Operating Instructions; Program Buttons; Indicator Lights - Magic Chef MCSMC6B Guia Del Usuario

OPERATING INSTRUCTIONS

Set up the unit on a level, stable surface close to a power outlet. Turn the Lid counter-
clockwise and lift to take it off the multicooker. Remove any accessories or manuals as well
as the Inner Pot, and put the Condensation Collector in place on the unit.
Put the food items to be cooked into the Inner Pot. Be sure that the food doesn't exceed the
"Max" level marking in the pot. Make sure the bottom and sides of the pot are clean and dry,
and carefully place in the multicooker. The inner pot must be flat on the bottom of the unit.
NOTE: DO NOT use the unit without the Inner Pot.
Verify that the Sealing Gasket is clean and clear of any debris or obstructions, and securely
placed in the proper position in the lid. Place the Lid on the unit and lock the Lid by turning the
handle clockwise.
CAUTION: If the Sealing gasket is dirty, in the incorrect position, or pinched between the lid and the Multicooker, the unit may not
be able to build up proper pressure and the lid may not lock shut. If the float valve does not raise to the up position while heating,
turn unit off and turn the Steam Release to 'Venting' for several minutes before attempting to remove the lid.
Put the Steam Handle into position and ensure that it is securely on. Make sure that it is down before pressure cooking in the unit.
NOTE: The Steam Handle does not lock into place and will remain somewhat loose.

PROGRAM BUTTONS

The program buttons are preprogrammed cook settings for your multicooker, allowing a variety of foods to be cooked with a
simple touch of a button, while also allowing the settings to be changed as needed or desired. (See Cooking Parameters Chart below)
DISPLAY
The display will show information regarding time and temperature and will give information such as when to put the lid on or take
it off depending on the program setting.

INDICATOR LIGHTS

• The Low Pressure and High Pressure indicator lights will illuminate to show if Low or High Pressure is set for cooking.
• Pressing the Pressure Level button will cycle between Low and High Pressure.
• The indicator lights for "Less/Normal/More" show the default time chosen for cooking with a specific function. Pressing the
desired function button will cycle between Less-Normal-More time.
• NOTE: Not all cooking programs can be adjusted. Refer to the Cooking Parameters chart below.
LESS/NORMAL/MORE
• Pressing the Program button will cycle between Default Cook times shown in the Cooking Parameters Table (below) for the
programs: Soup/Broth, Meat/Stew, Bean/Chili, Multigrain, Oatmeal, Steam, Pressure Cook, Slow Cook, Sauté/Sear, Rice, Cake and Yogurt .
Figure 5
a. Program Buttons w/ Indicator Light
b. Display
c. Indicator Lights
d. "+" and "-" Buttons
e. Pressure Level Button
f. Pressure Cook Button
g. Delay Start Button
h. Keep Warm/Cancel Button
8
Figure 4