Emerson KEANE CF320BS00 Manual Del Usuario página 8

3. Ceiling Fan Assembly
3.9
Turn the partially assembled ceiling fan upside down, place
the ceiling fan onto the two carton styrofoam pieces, in
preparation for final assembly (Figure 9).
Remove the six shipping spacers and the spacer
attachment screws from the motor before installation of
blade assemblies (Figure 9).
Discard the six shipping spacers and spacer screws.
3.10
NOTE: Intermixing blades between fans can cause
excessive wobble. Keep blades in original sets of
three.
Place the fan blade flange on the fan blade (Figure 10).
Place the decorative blade nut onto the underside of the
fan blade (Figure 10).
Tighten the #8-32 x 0.312" washer head screw to secure
(supplied in parts bag) the fan blade and the decorative
blade nut (Figure 10).
Repeat this procedure for the other two fan blade flanges,
decorative blade nut and fan blades.
Make sure all #8-32 x 0.312" washer head screws are
tighten securely to the decorative blade nut to secure the
fan blade and flange.
3.11
Loosely attach one blade/flange assembly to the motor
hub by securing the two 1/4-20 x .500" oval head
countersunk screws (Figure 11).
Repeat this procedure for other two blade assemblies.
Tighten all the 1/4-20 x .500" oval head countersunk
NOTE: Take care not to scratch fan housing when
screws to the motor hub at this time.
installing blades.
WARNING
!
To reduce the risk of personal injury, do not bend the
blade flange when installing the blade flanges,
balancing the blades or cleaning the fan. Do not insert
foreign objects in between rotating fan blades.
(Continued)
PARTIALLY ASSEMBLED
CEILING FAN
Figure 9
BLADE
DECORATIVE
BLADE NUT
(3 per blade/flange)
Figure 10
1/4-20 x .500" OVAL HEAD
COUNTERSUNK SCREWS
(2 per blade/flange assembly)
MOTOR HUB
Figure 11
8
REMOVE & DISCARD
SHIPPING SPACERS &
ATTACHMENT SCREWS (6)
#8-32 X 0.312"
WASHER HEAD
SCREWS
FLANGE
BLADE/
FLANGE
ASSEMBLY
ETL Model No.: CF320