Pioneer XV-DV900 Manual De Instrucciones página 3

[For South American models]
On the inside cover of the unit
CAUTION :
VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN. AVOID EXPOSURE TO BEAM.
SICHTBARE UND UNSICHTBARE LASERSTRAHLUNG, WENNABDECKUNG GEÖFFNET
VORSICHT :
NICHT DEM STRAHL AUSSETZEN!
SYNLIG OG USYNLIG LASERSTRÅLING VED ÅBNING UNDGÅ UDSÆTTELSE FOR
ADVARSEL :
STRÀLING.
SYNLIG OCH OSYNLIG LASERSTRÅLNING NÄR DENNA DEL ÄR ÖPPNAD BETRAKTA
VARNING :
EJ STRÅLEN.
AVATTAESSA ALTISTUT NÄKYVÄ JA NÄKYMÄTTÖMÄLLE LASERSATEIL YLLE. ÄLÄ
VARO! :
KATSO SÄTEESEN.
RADIACIÓN LÁSER VISIBLE E INVISIBLE AL ESTAR ABIERTO. EVITAR EXPOSICIÓN AL
CUIDADO :
RAYO.
[For South American models]
LINE VOLTAGE SELECTOR SWITCH
Only multi-voltage model is provided with
this switch.
XV-DV700(Australian model) is not
provided with this switch.
The line voltage selector switch is located on
the rear panel. Check that it is set properly
before plugging the power cord into the
outlet. If the voltage is properly set or if you
move to an area where the voltage
requirements differ, adjust the selector
switch as follows:
• Be sure to disconnect the power cord from
its outlet before making this adjustment.
• Use a medium-sized(flat blade) screwdriver.
Insert the tip of the screwdriver into the
groove of the selector switch and turn it so
that the power voltage marking of your
area points to the arrow.
Power source voltage is factory adjusted
240 volts. If your area is different, change
voltage selectors settings.
H038En
VRW1872
VOLTAGE SELECTOR
240 V
220V
–230V
110V
–127V
CAUTION 240 V
H014 En