Front-Panel Error Codes - HP DesignJet Z6610 60" Manual Del Usuario

Setup menu icon
then press the OK

Front-panel error codes

The printer may occasionally display a system error, consisting of a numerical code followed by the recommended
action that you should take.
In most cases you will be asked to restart the printer, because when the printer starts it can diagnose the issue
better and may be able to fix it automatically. If the problem persists after restarting, you should contact your HP
support representative and be ready to give the numerical code from the error message.
If the error message contains some other recommended action, follow the printer's instructions.
Text messages
Message
[Color] cartridge has expired
[Color] cartridge is incorrect
[Color] cartridge is missing
[Color] cartridge is out of ink
[Color] printhead #[n] error: please remove
[Color] printhead #[n] error: replace
Faulty cartridge. Replace [color] cartridge
PDL Error: Ink system not ready
Replace [color] cartridge
Reseat [color] cartridge
26.n.01 (where n = the ink cartridge number)
29.01
32.1.01
32.2.01
ENWW
, then Front panel options > Sleep mode wait time. Highlight the wait time you want and
key. You can set the time from 1 to 240 minutes. The default time is 25 minutes.
Recommendation
Replace the cartridge.
Replace the cartridge by one supported in this region.
Insert a cartridge of the correct color.
Replace the cartridge.
Remove the incorrect printhead and insert a new printhead of the
correct type (color and number).
Remove the non-functional printhead and insert a new printhead.
Replace the cartridge.
Clean the printheads.
Replace the cartridge.
Remove and reinsert the same cartridge.
Remove ink cartridge n and reinstall it in the printer. If the error persists,
replace the ink cartridge. If the problem persists, contact HP Support.
The maintenance cartridge is not inserted correctly. Open the
maintenance cartridge door on the right side of the printer, make sure
that the maintenance cartridge is correctly seated, and then close the
door. If the problem persists, replace the maintenance cartridge. If the
problem persists, contact HP Support.
A take-up reel error has occurred. Make sure that the paper is
adequately taped to the take-up reel spindle core, and then make sure
that the winding direction is correctly set.
The take-up reel cannot be detected. Make sure that the take-up reel
sensor cable is correctly connected.
Front-panel error codes
5