Start-Up And Use - SCHOLTES TGL 640 Manual De Instrucciones

Start-up and use

! The position of the corresponding gas burner or
GB
electric hotplate is shown on every knob.
Gas burners
Each burner can be adjusted to one of the following
settings using the corresponding control knob:
0 Off
Maximum
Minimum
To light one of the burners, hold a lit match or lighter
near the burner and, at the same time, press down
and turn the corresponding knob anti-clockwise to the
maximum setting.
Since the burner is fitted with a safety device, the
knob should be pressed for approximately 2-3
seconds to allow the automatic device keeping the
flame alight to heat up.
When using models with an ignition button, light the
desired burner pressing down the corresponding knob
as far as possible and turning it anticlockwise
towards the maximum setting.
! If a flame is accidentally extinguished, turn off the
control knob and wait for at least 1 minute before
trying to relight it.
To switch off the burner, turn the knob in a clockwise
direction until it stops (when reaches the "0" position).
The "separate double flame" burner*
This burner consists of two concentric burners which
can operate either together or separately.
Use of the double flame on the maximum setting
gives a very high power which reduces cooking times
with respect to conventional burners.
Moreover the double flame crown provides a more
uniform distribution of heat on the bottom of the pan,
when using both burners on minimum.
To ensure that the double-flame burner is used to its
full potential, never set the inside ring to minimum
and the outside ring to maximum at the same time.
Pots and pans of all sizes can be used. In the case
of the smaller pots and pans we recommend the use
of only the internal burner.
There is a separate control knob for each of the
"separate double flame" burners.
The knob marked by the symbol
external burner;
The knob marked by the symbol
internal burner.
To turn on one of the rings, press the relative knob in
all the way and turn it anti-clockwise to the high
18
setting
igniter that automatically starts when the knob is
pressed in.
Since the burner is equipped with a safety device,
after lighting the burner keep the knob pressed in for
about 2-3 seconds to allow the device which keeps
the flame lit automatically to heat up.
The selected burner can be regulated using the
corresponding knob, as follows:
0
To switch off the burner, turn the knob in a clockwise
direction until it stops (when reaches the "0" position).
operates the
operates the
. The burner is fitted with an electronic
Off
Maximum
Minimum