Start-Up And Use; Gas Burners; Practical Advice On Using The Burners; Burner - SCHOLTES BQ 50TC Manual De Instrucciones

Start-up and use

! The position of the corresponding gas burner or
GB
electric hotplate* is shown on every knob.

Gas burners

Each burner can be adjusted to one of the following
settings using the corresponding control knob:
0 Off
v Maximum
Minimum
To light one of the burners, hold a lit match or lighter
near the burner and, at the same time, press down
and turn the corresponding knob anti-clockwise to the
maximum setting.
Since the burner is fitted with a safety device, the
knob should be pressed for approximately 2-3
seconds to allow the automatic device keeping the
flame alight to heat up.
When using models with an ignition button, light the
desired burner pressing down the corresponding knob
as far as possible and turning it anticlockwise
towards the maximum setting.
! Some models have a Double Flame burner. In this
case, to activate it, simply start by turning the knob
so that it is aligned with the
it all the way in and hold it in this position for
approximately 6 seconds, until the automatic device
keeping the flame alight has heated up.
! If a flame is accidentally extinguished, turn off the
control knob and wait for at least 1 minute before
trying to relight it.
To switch off the burner, turn the knob in a clockwise
direction until it stops (when reaches the "0" position).
The "separate double flame" burner*
This burner consists of two concentric burners which
can operate either together or separately.
Use of the double flame on the maximum setting
gives a very high power which reduces cooking times
with respect to conventional burners.
Moreover the double flame crown provides a more
uniform distribution of heat on the bottom of the pan,
when using both burners on minimum.
To ensure that the double-flame burner is used to To ensure that the double-flame burner is used to
To ensure that the double-flame burner is used to To ensure that the double-flame burner is used to To ensure that the double-flame burner is used to
its full potential, never set the inside ring to mini- its full potential, never set the inside ring to mini- its full potential, never set the inside ring to mini- its full potential, never set the inside ring to mini- its full potential, never set the inside ring to mini-
mum and the outside ring to maximum at the mum and the outside ring to maximum at the mum and the outside ring to maximum at the mum and the outside ring to maximum at the mum and the outside ring to maximum at the
same time. same time. same time.
same time. same time.
Pots and pans of all sizes can be used. In the case
of the smaller pots and pans we recommend the use
of only the internal burner.
There is a separate control knob for each of the
"separate double flame" burners.
22
symbol, then press
The knob marked by the symbol
external burner;
The knob marked by the symbol
internal burner.
To turn on one of the rings, press the relative knob in
all the way and turn it anti-clockwise to the high
setting. The burner is fitted with an electronic igniter
that automatically starts when the knob is pressed
in.
Since the burner is equipped with a safety device, Since the burner is equipped with a safety device, Since the burner is equipped with a safety device, Since the burner is equipped with a safety device, Since the burner is equipped with a safety device,
after lighting the burner keep the knob pressed in for
about 2-3 seconds to allow the device which keeps
the flame lit automatically to heat up.
The selected burner can be regulated using the
corresponding knob, as follows:
0 Off
Maximum
Minimum
To switch off the burner, turn the knob in a clockwise
direction until it stops (when reaches the "0" position).

Practical advice on using the burners

To ensure the burners operate efficiently:
• Use appropriate cookware for each burner (see
table) so that the flames do not extend beyond the
bottom of the cookware.
• Always use cookware with a flat base and a cover.
• When the contents of the pan reach boiling point,
turn the knob to minimum.

Burner

A.Auxiliary
B.Semi-rapid

C.Rapid

D. Triple ring
I.D ouble ring D C -D R (inner)
I.D ouble ring D C -D R (outer)
Note
Note When there is no electricity supply, the burners can be
lit with a match after turning the control knob to the flame
position.
To turn on one of the burners, place a lighted match or
lighter near the burner, press the knob all the way in and
turn it anti-clockwise to the "High" setting.
operates the
operates the
ø Pan D iameter (cm)
6 – 14
15 – 20
21 – 26
24 - 26
10 - 14
24 - 28