Telstar TPI060210MD Manual De Instrucciones página 42

Pans do not become
hot and appears in the
display.
The induction hob or a
cooking zone has turned
itself off unexpectedly, a
tone sounds and an error
code is displayed
(typically alternating
with one or two digits
in the cooking timer
display).
Failure Display and Inspection
If an abnormality comes up, the induction hob will enter the protective state automatically and display corre-
sponding protective codes:
Problem
F3-F8
F9 – FE
E1 / E2
E3 / E4
E5 / E6
The above are the judgment and inspection of common failures.
Please do not disassemble the unit by yourself to avoid any dangers and damages to the induction hob.
The induction hob cannot
detect the pan because it is not
suitable for induction cooking.
The induction hob cannot detect
the pan because it is too small
for the cooking zone or not
properly centred on it.
Technical fault.
Possible causes
Temperature sensor failure
Temperature sensor of the IGBT
failure.
Abnormal supply voltage
Abnormal temperature
Bad induction hob heat
radiation
Use cookware suitable for induction
cooking. See section 'Choosing the
right cookware'.
Centre the pan and make sure that its
base matches the size of the cooking
zone.
Please note
and numbers, switch the power to the
induction hob off at the wall, and contact
a qualified technician.
What to do
Please contact the supplier.
Please contact the supplier.
Please inspect whether power
supply is normal.
Power on after the power
supply is normal.
Please inspect the pot.
Please restart after the
induction hob cools down.
42
INDUCTION COOKER
TPI060210MD
down the error letters