Sauder Palladia Serie Manual De Montaje página 14

10 10
If the TOPS (J, K and L)
have an unfi nished suface,
it should be facing up.
K
NOTE: You will need someone's help with Steps 10 and 11.
Position the TOPS (J, K and L) as shown with the holes closer to the inside edge. Follow the diagram.
Fasten a SLAT (G) to the TOPS (J, K and L). Use eight BLACK 1-1/8" PAN HEAD SCREWS (FF).
Fasten the remaining SLATS (G) to the LONG TOPS (J and K). Use sixteen BLACK 1-1/8" PAN HEAD SCREWS (FF).
Page 14
BLACK 1-1/8" PAN HEAD SCREW
(24 used in this step)
Rounded
edge
G
G
G
www.sauder.com/services
FF
G
L
G
The holes in the TOPS (J, K and L)
J
must be closer to the inside edge.
Rounded
edge
413998