Sauder Palladia Serie Manual De Montaje página 6

2 2
W
V
Push the black lever in and pull the SLIDE from the RAIL.
Open end
Finished edge
V
I
V
Finished edge
V
I
Open end
V
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
II
Separate the EXTENSION SLIDES (W) from the EXTENSION RAILS (V) as shown in the upper diagram. Be prepared, the parts
are greasy.
Fasten four EXTENSION RAILS (V) to the DRAWER UPRIGHTS (I). Use eight GOLD 5/16" FLAT HEAD SCREWS (II).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other hole that lines up with the hole in the UPRIGHTS. Turn a SCREW into this
hole.
Page 6 www.sauder.com/services 413998