En: Installation Sheet; Product Description - Interlogix PB611M Hoja De Instalación

EN: Installation Sheet

Product description

This product is a photoelectric beam sensor designed to be
installed in a beam tower (sold separately).
The beam tower to be used is recommended to be rated IP 55
or better.
The PB6xxx-series intelligent photoelectric beam is especially
designed for outdoor protection.
Unique "Quad" beams are synchronized to work together to
reinforce the range and stability in severe weather conditions.
The PB series beams are equipped with many features which
provide a wide choice of field selectable options.
These options result in considerable flexibility for a variety of
application requirements.
•
4 synchronized high power infrared.
•
Four frequencies selections.
•
Beam transmission strength selection.
•
Easy beam alignment.
•
Auto-gain lock.
•
Environmental module built-in.
Figure description
Figure 1 description - Part descriptions
1 Mirror
2 Horizontal angle adjuster
3 Vertical angle adjuster
4 Terminals
Gain lock switch （receiver only）
5
6 / 40
6 Indication panel
7 Mirror
8 Adjustment dial
9 Shading plate
10 Viewfinder
Panhead screw （M3×12）x8
11
12 Lock spacer
Figure 2 description - Functions/indications of the transmitter (Tx)
and the receiver (Rx)
1 Operation LED
Beam frequency selectable switch （factory set：1ch）
2
Beam power selection switch （factory set： H）
3
4 Response time adjustment
Beep switch （factory set： OFF）
5
6 Sensitivity LED
7 Alarm LED
8 Monitor jack
9 Memory LED
Beam frequency selectable switch （factory set： 1ch）
10
Alarm output selectable switch （factory set： N.C.）
11
Alarm memory selectable switch （factory set： manual）
12
Environmental output selector （factory set： N.C.）
13
14 Environmental output terminal
15 Alarm memory terminal
Figure 9 description - Adjusting the optical angle
1 Viewfinder
2 Horizontal angle adjustment screw
3 Vertical angle adjustment screw
4 Adjustment dial
P/N 1070011 • REV C • ISS 19MAR19