Set Up Main Unit; Weather Information Display; Regional Weather Information - Oregon Scientific WMH90 Manual De Usuario

The remote sensor reception icon will show the following
status:
ICON
NOTE The main unit will search only for already
registered sensor or new sensor reset within last 30
minutes. To register a new sensor, reset sensor prior
to search.
TIP The transmission range may vary depending on
many factors. You may need to experiment with various
locations to get the best results.

SET UP MAIN UNIT

NOTE Set up the remote sensor before installing the
main unit.
1. Remove the battery compartment cover.
2. Insert the batteries, matching the polarities.
3. Press RESET after each battery change.
P/N: 300100781-00004-10 REV 1
6/86
WMH90_M_EU_EN_R5.indd 5
NOTE Batteries should not be exposed to excessive
heat such as sunshine or fire.
DESCRIPTION

WEATHER INFORMATION DISPLAy

Main unit is
searching for

REGIONAL WEATHER INFORMATION

sensor(s).
NOTE Due to timing of the transmission of weather data,
A channel has
it may take up to 24 hours to get a valid signal.
been found.
Initial synchronisation with Meteo Time can take from 2 to
12 hours. If the weather forecast icons do not appear after
The sensor
a long period of time, please reset the product and place
cannot be found.
it next to a window or a place with less signal interference.
This unit displays the current and next 3-day* weather
information of a user-selected regional city.
strong signal reception of weather information.
* 4-day weather information (current and next 3-days) is
not available for all cities. Please refer to 'Geographical
coverage' addendum sheet for a list of cities and the
available forecasts for each city.
5
ICON LOCATION
Clock / Alarm /
Calendar /
Message area
Today's Weather /
Regional Weather
area
indicates
DESCRIPTION
Some cities' data
are received
Data for the
selected city
received in the
past 48 hours
11-7-27 下午4:56