Bagging The Clippings; Installing The Grass Bag - Toro Super Recycler Manual Del Operador

Bagging the Clippings

Use the grass bag when you want to collect grass and leaf clippings from the lawn.
Note:
By default this machine is equipped with an economy blade for improved runtime; it also includes an
optional performance blade for improved bagging and performance. Before bagging, install the performance
blade; refer to Replacing the Blade (page

Installing the Grass Bag

1. Shut off the machine and wait for all moving parts to stop; refer to
2. Remove the battery pack from the machine; refer to
(page 24).
3. Raise and hold up the rear deflector (A of
4. Remove the rear-discharge plug by pushing in the latch with your thumb and pulling the plug out from
the machine (B and C of
5. Install the bag-rod ends into the notches at the base of the handle, and rock the bag back and forth to
ensure that the bag-rod ends are seated at the bottom of both notches (D of
6. Lower the rear deflector until it rests on the grass bag.
28).
Figure
Figure 20).
Figure 20
Shutting Off the Machine (page
Removing the Battery Pack from the Machine
20).
23
22).
Figure 20).
g367752