Rubbermaid 5L10 Instrucciones De Uso Y De Instalacion página 5

3.0 Wall Panel G Installation
G
b.
Drill a pilot hole (using 1/8" drill bit) in front lower corner
at location indicated by screw target.
Note: This pilot hole is to be drilled through both walls.
G
A
a.
Using a screwdriver, punch out the screw holes on the
top of Front Left Side (G) 2 places.
c.
Snap Front Left Side (G) into Front Floor (A).
Hold Front Left Side (G) upright to prevent it from
falling (until Left Back (D) is installed).
ALIGN
Screw Holes
G
G
click
ALIGN
A
5