User Information - Festo CP FB6-E Breve Descripción

CP FB6-E
1

User information

The CP fieldbus node 6 is designed exclusively for use as a
slave on the INTERBUS. The limit values of the technical speci-
fications must be observed.
Please refer to the manual P.BE CP-FB6-E... for detailed infor-
mation.
WARNUNG:
• Switch off the power supply before you connect or
disconnect plugs (danger of functional damage).
• Use only power units which guarantee reliable isolation
of the operating voltages as per IEC 742/EN 60742/
VDE 0551 with at least 4 kV isolation resistance (protected
extra low voltage, PELV, see adjacent designation).
Switch power packs are permitted if they guarantee
reliable isolation in accordance with EN 60950/VDE 0805.
• Connect a protective earth conductor with sufficient
cross section to the connection marked with
PLEASE NOTE
Only operate a node which is completely fitted and electri-
cally wired.
9809c
.
11