General Safety Information; Mounting And Connecting; Qualification Of Specialized Personnel - Festo DNCKE S Serie Instrucciones De Utilizacion

DNCKE−...−S / KEC−...−S
2.4

General safety information

WARNING
Risk of injury! Uncontrolled movement. Piston rods can move out suddenly and
unexpectedly, thereby causing injury to anybody who is in the positioning range.
• Make sure that nobody can place his/her hand in the positioning range of
the payload.
• Make sure that no foreign objects are present in the positioning range of
the payload.
• Do not make any modifications to the product. Improper modifications impair
the functioning and represent a safety risk.
The operating modes must guarantee that the residual risk is less than/equal to the accepted risk
(è DIN EN ISO 12100). The measures for risk reduction are to be taken in accordance with
DIN EN ISO 4414, DIN EN ISO 12100 and DIN EN ISO 13849-1.
Monitor/check the function of the entire system during use in accordance with the measures defined in
the validation report (è DIN EN ISO 13849-2).
• Take into consideration the applicable legal regulations for the respective destination.
• Only use the product if it is in its original status and in an excellent technical status.
• Use the product only within the defined values (è 13 Technical data).
• Take into account labelling on the product.
• Observe other applicable documents.
• Take into consideration the ambient conditions at the location of use.
• Protect the product during storage and operation from the following:
– wetness or moisture
– corrosive coolant or other materials (e.g. ozone)
– UV radiation
– oils, greases and grease-solvent vapours
– grinding dust
– glowing chips or sparks
2.5

Mounting and connecting

• Observe tightening torques. Unless otherwise specified, the tolerance is ±20 %.
2.6

Qualification of specialized personnel

Only qualified specialized personnel may perform installation, commissioning, maintenance and disas­
sembly of the clamping unit. The qualified personnel must be familiar with installation and operation of
electrical and pneumatic control systems.
Festo – DNCKE−...−S / KEC−...−S – 1511b English 33