Display Bracket Assembly Instructions - Health O Meter Professional 498 KL Manual De Instrucciones

DISPLAY BRACKET ASSEMBLY INSTRUCTIONS

Display Bracket Assembly
Note: Do not use display bracket for wall mount. Display bracket is for surface use only. For wall mounting,
mount display assembly directly to the wall, see page 8.
1. Carefully remove the scale platform with the display assembly from the carton, and place the scale platform
and display assembly on a flat, level, and dry surface.
2. Remove the display bracket from the carton.
3. Remove the two small screws from plate B.
4. While holding plate A, slide the tab of plate B up and under the center tab on the back of plate A.
5. Align plate A and plate B, and ensure that the screw holes are lined up.
6. Insert the two small screws into the front of plate A and through the holes in plate B.
7. Using a Phillips head screwdriver, tighten the screws to secure plate A to plate B.
8. Slide the two mounting studs on the display bracket into the two mounting holes in the back of the display
assembly. The display bracket is now ready for use.
Plate A
Display Bracket
Screws
Tab
Plate B
Mounting studs
Center tab
Screw
holes
7