Display Wall Mount Instructions - Health O Meter Professional 498 KL Manual De Instrucciones

DISPLAY WALL MOUNT INSTRUCTIONS

Caution: When wall mounting the display assembly, ensure that the mounting location is free of electrical
lines, gas pipes, and other safety hazards. Ensure that wall is of construction that can support the
display assembly.
Note: Remote head can be mounted to a wall up to 6 feet (1.83 m) from the base or it can be mounted on the
display bracket (included) for placement on a table up to 6 feet (1.83 m) from the base.
Note: For wall mounting, mount display assembly directly to the wall. Do not use display bracket for wall
mount. Display bracket is for surface use only.
Required Parts
(1) Display assembly
(2) #8 Anchoring screws (4.2 mm nominal OD) (NOT INCLUDED)
(2) Mounting anchors, compatible with wall construction (NOT INCLUDED)
1. Position the display assembly on the wall, and carefully trace around the display outline.
2. Mark a level horizontal line, 2.75" (70 mm) below the top of the display outline.
3. Mark a vertical line 3.1" (80 mm) from each side of the display outline.
4. Use the appropriate plastic or metal anchors for the type of wall construction.
5. At the horizontal and vertical intersections, carefully drill the appropriate sized holes.
6. Insert the anchors into the wall, and screw the two mounting screws into the anchors. Adjust the screw
head depth such that the screw heads protrude 0.125" (3.2 mm) from the wall. Warning: Extending the
screw heads beyond 0.125" (3.2 mm) can damage the display assembly.
7. Position the display assembly mounting holes onto the mounting screws and pull down on the display
assembly to secure the bracket over the screws.
Mounting hole
3.1" (80 mm)
2.75" (70 mm)
Mounting hole
8
Display assembly
3.1" (80 mm)