Alls With The - GE 29472 Manual De Instrucciones

NOTE: Only one-way conversation is possible in speakerphone mode. When
you are speaking, you are transmitting. When you are listening, you are
receiving. You can't do both at the same time. The phone will automatically
switch between transmitting and receiving depending on the level of the voice
or the room noise picked up by the speakerphone mic.
M C
AKING

ALLS WITH THE

1. Connect the headset plug to the jack on the side of the base.
2. Press the HEADSET button to enable the headset. The HEADSET
indicator blinks.
3. Press the line you want to use.
4. Wait for a dial tone then dial a phone number.
5. When finished, press the HEADSET button to turn it off.
CAUTION: Use only the ATLINKS USA, Inc. 5-2425 headset that is
compatible with this unit. Using other headsets may damage the
unit. To order a new headset, call the Thomson Mail Order
Department at 1-800-338-0376.
NOTE: If the headset is not connected, an error tone is heard if the
HEADSET button is pressed.
NOTE: When you are using the phone on one line and another call comes in on
another line, you will hear a incoming call tone two beeps for three ring cycles at
the handset, speakerphone, or headset. If you don't want to hear this incoming
call tone, you may turn it off. See Incoming Call Tone Enable/Disable.
R C
ECEIVING ALLS WITH THE
When the phone rings, the corresponding line's indicator flashes rapidly.
1. Pick up the handset, and the phone automatically selects the ringing line.
2. When you are finished, hang up the handset.
H
EADSET
H
ANDSET
21