Sanus DECORA DMF115 Manual De Instrucciones página 11

3. Drill pilot holes using a 7/32 in. (5 mm) diameter drill bit. Remove wall plate template
IMPORTANT: Be sure to drill into the center of the stud.
IMPORTANT: Pilot holes must be drilled to a depth of 3 in. (75 mm).
4. Install wall plate assembly
wall plate.
CAUTION:
Improper use could reduce the holding power of the lag bolt. DO NOT over-tighten the lag bolts.
3
17
20
18
using two lag bolts and two washers
3 in. (75 mm)
7/32 in.
(5.5 mm)
17
.
19
. Tighten the lag bolts only until they are pulled firmly against the
4
19
20
20
18
19
11