Sanus DECORA DMF115 Manual De Instrucciones página 13

3. Remove the wall plate template
CAUTION:
Be sure the anchors are seated flush with the concrete surface.
4. Install wall plate assembly
CMK1). Tighten the lag bolts only until they are pulled firmly against the wall plate.
CAUTION:
Improper use could reduce the holding power of the lag bolt. DO NOT over-tighten the lag bolts.
*
Contact Customer Service at 1-888-333-9952 to have the Concrete Installation Kit CMK1 shipped directly to you.
3
17
and insert three anchors (Fischer UX 10 x 60 - included in the Concrete Installation Kit CMK1*).
18
using three lag bolts and three washers (use only the lag bolts and washers from the Concrete Installation Kit*
*
4
*
18
*
13