Listo RDL 130-50b4 Instrucciones De Uso página 33

Problems
The appliance does not
cool down enough. The
food is too warm.
Unusual noises.
The compressor does not
start immediately after
changing the temperature
setting.
There is water at the back
of the appliance or on the
shelves.
If the information in this table does not help you solve your specific problem, do not
perform any repairs on the appliance yourself. Contact your retailer's after-sales
service department.
IMPORTANT: Repairs to your refrigerator should only be carried out by qualified
service technicians. Improper repairs can be hazardous to users and are not
covered by the warranty.
i
n CAse of prolonged AbsenCe or non
• Put the thermostat in the "Off" position.
• Unplug, empty, defrost and clean the appliance.
• Keep the doors ajar to prevent odours from forming.
Possible causes
The temperature is not set
correctly.
The door was open too
long.
A large amount of hot
food has been placed in
the appliance in the past
24 hours.
The appliance is located
near a heat source.
The appliance is not
straight.
The appliance is touching
the wall or other objects.
Some noises are typical for
refrigeration appliances.
This is normal, it is not a
malfunction.
The defrost
discharge outlet
blocked.
-
use
33
Solutions
Please refer to the "Setting
the temperature" section.
Do not open the door
longer than necessary.
Temporarily
thermostat to a cooler
temperature.
overloading the inside of
the refrigerator.
Please refer
"Installation
section.
Adjust the feet.
Move the appliance
slightly.
Refer to the "Noises when
running" section.
The compressor will start
after a while.
water Refer to the "Cleaning and
is Maintenance" section.
set the
Avoid
to the
location"
V.1.0