jbc HDE-B Manual De Instrucciones página 16

Safety
It is imperative to follow safety guidelines to prevent electric
shock, injury, fire or explosion.
- Do not use the units for any purpose other than soldering or rework. Incorrect use may cause fire.
- The power cord must be plugged into approved bases. Make sure that it is properly grounde
before use. When unplugging it, hold the plug, not the wire.
- Do not work on electrically live parts.
- The tool should be placed in the stand when not in use in order to activate the sleep mode.
The soldering tip, the metal part of the tool and the stand may still be hot even when the station
is turned off. Handle with care, including when adjusting the stand position.
- Do not leave the appliance unattended when it is on.
- Do not cover the ventilation grills. Heat can cause inflamable products to ignite.
- Avoid the contact of flux with skin or eyes to prevent irritation.
- Be careful with the fumes produced when soldering.
- Keep your workplace clean and tidy. Wear appropriate protection glasses and gloves when
working to avoid personal harm.
- Utmost care must be taken with liquid tin waste which can cause burns.
- This appliance can be used by children over the age of eight and also persons with reduced
physical, sensory or mental capabilities or lack of experience provided that they have been given
adequate supervision or instruction concerning use of the appliance and understand the hazards
involved. Children must not play with the appliance.
- Maintenance must not be carried out by children unless supervised.
Specifications
HDE-1B 120V 50/60Hz. Input fuse: 4A. Output: 47V.
HDE-2B 230V 50/60Hz. Input fuse: 2A. Output: 47V.
HDE-9B 100V 50/60Hz. Input fuse: 4A. Output: 47V.
- Weight:
- Dimensions:
- Output Peak Power:
- Temperature Range:
- Idle Temp. Stability (still air):
- Tip to ground resistance:
- Tip to ground voltage:
- Ambient operating temp:
- Connections station-PC
Complies with CE standards
ESD protected housing "skin effect"
16
6,1 Kg (13.45 lb)
145 x 120 x 225 mm (5.70 x 4.72 x 8.86 in)
250W
90-500 ºC (190-932 ºF) (±5%)
±1.5 ºC (±3 ºF)
<2 ohms
<2mV RMS
10 - 40 ºC (50 - 104 ºF)
USB / Peripherals connector / RJ12 connector for Robot