Types Of Work; Rough Grinding; Switching On (Switch With Lock) - Hilti DCG 700-P Manual De Instrucciones Original

2. Press the spindle lockbutton and hold it in this position.
3. Release the clamping nut by gripping it with the pin wrench and turning the nut counterclockwise.
4. Release the spindle lockbutton and remove the accessory tool.
6.8 Adjusting the side handle
WARNING
Risk of injury. If the grip position is adjusted while the tool is in operation it is no longer possible to hold the
tool in a stable position, resulting in a risk of accident.
▶ Do not, under any circumstances, attempt to adjust the grip while the tool is running.
▶ Check to ensure that the grip is engaged in one of the three possible positions.
1. Disconnect the supply cord plug from the power outlet.
2. Release the locking lever by pulling it back.
3. Pivot the grip to the left or right as far as it will go.
4. Secure the grip in position by closing the locking lever.
The angle grinder cannot be switched on so long as the side handle is not locked in one of the
three possible positions.
7

Types of work

WARNING
A damaged supply cord presents a hazard! Do not touch the supply cord or extension cord if damaged
while working. Disconnect the supply cord plug from the power outlet.
▶ Check the appliance's supply cord at regular intervals and have it replaced by a qualified specialist if
found to be damaged.
Check extension cords at regular intervals and replace them if found to be damaged.
7.1 Grinding
CAUTION
Risk of injury. The accessory tool may suddenly stick or stall.
▶ Use the power tool with the side handle fitted and always hold it securely with both hands.
7.1.1

Rough grinding

CAUTION
Risk of injury. The abrasive cutting disc could shatter and flying fragments may cause injury.
▶ Never use abrasive cutting discs for grinding.
▶ Move the power tool to and fro while maintaining a 5° to 30° angle of attack and applying moderate
pressure.
◁ This will avoid overheating and discoloration of the workpiece and help ensure an even surface finish.
7.1.2 Cutting
▶ When cutting, apply moderate feed pressure and do not tilt the power tool or, respectively, the cutting
disc (hold at approx. 90° to the surface being cut).
For best results when cutting profiles and square tube, start cutting at the smallest cross section.
7.2

Switching on (switch with lock)

1. Plug the supply cord into the power outlet.
2. Push the on/off switch forward (3 mm).
3. Press the on/off switch and push it forward it as far as it will go into the pressed position until it engages.
◁ The motor runs.
10 English
Printed: 29.03.2018 | Doc-Nr: PUB / 5164457 / 000 / 01
6
72022
*72022*