Optika Italy B-1000 Serie Manual De Instrucciones página 7

Insert the optical head above
the attachment using the other
3mm Allen wrench to tighten
the screw. (Fig.2)
Insert the extension tube
on the rear of the incident
illumination attachment, then
use an allen wrench to fix it.
(Fig.3)
Insert the lamp house into the
extension tube, then use an
allen wrench to fix it. (Fig. 4)
Insert both eyepieces into
the tubes of the optical head.
(Fig.5)
Insert the condenser under
the stage: push until it is well
inserted into its holder (under
the condenser there is a pin
that must fully enter the guide
of the holder). (Fig.6)
Page 7
Fig.2
Fig.3
Fig.4
Fig.5
AFTER INSERTING THE
CONDENSER, TIGHTEN
THIS SCREW
Fig.6