Step 4, Install Duct Bracket - Monogram ZV750 Instrucciones De Instalación

INSTALLATION – VENTED TO THE OUTSIDE
4
INSTALL DUCT BRACKET
VENTING TO THE REAR (HORIZONTAL EXHAUST)
OR STRAIGHT UP TOP (VERTICAL EXHAUST)
■ Temporarily install the 2 small screws into the sides of
the duct bracket. Remove the screws. This will ensure
ease of final installation.
■ Position the upper duct bracket against the wall and
ceiling, aligned with CL pencil mark and CL on the
bracket.
■ Mark the 4 screw locations of the bracket.
■ Remove the bracket.
■ Drill 1/8" pilot holes in marked bracket location.
■ If pilot holes do not enter studs, enlarge the holes 3/8"
and install wall-fastener anchors. Drive screws into the
fasteners to allow anchors to expand against the wall
material. Remove the screws.
■ Secure the bracket to the ceiling and wall with wood
screws and/or wall-fastener screws.
31-10724-7
Installation Instructions
Duct bracket
Rear or
horizontal
exhaust
Top or
vertical
exhaust
11