Step 7, Install Duct Cover And Utensil Rods; Step 8, Install Filters; Step 9, Finalize Installation - Monogram ZV750 Instrucciones De Instalación

INSTALLATION – VENTED TO THE OUTSIDE
7
INSTALL DUCT COVER AND
UTENSIL RODS
Assemble the duct covers
as shown.
For this vented installation,
place upper duct piece
inside the lower duct
piece. The inner duct
cover venting holes should
be positioned toward the
bottom end and should not
be visible.
■ Insert the assembled
duct covers into the
impression on the top of
the hood.
■ Extend the inner duct cover upwards to meet the
ceiling and bracket. (The vent holes should not be
visible in this installation.)
■ Secure the duct cover to the bracket with the 2 small
duct cover screws provided.
■ Install the side utensil rods as shown with screws
provided.
8
INSTALL FILTERS
Lower charcoal
filter channel
■ Remove protective film on filters.
658Dia59A
■ Tip the filter into the lower channel at the rear of the
opening, push back, lift and pull the knob forward until
the filter rests on the channel.
9
FINALIZE INSTALLATION
■ Remove protective film covering the control panel
on the front face of the hood and any remaining
packaging materials.
■ Make sure the filters are seated properly when
installed and the filter light is not on.
31-10724-7
Installation Instructions
Mounting Screws
Bottom
Notches
447Dia24
Install optional accessory ZX7510SPSS
(if needed to reach taller ceiling heights)
■ Separate the supplied duct cover into pieces. Discard
the lower (outer) section.
■ Slide the new ZX7510SPSS duct cover onto the
original upper section. Be sure that the longer section
is outside the shorter original section. The notches will
be at the bottom and the screw holes at the top as
illustrated.
■ Secure the duct cover to the bracket with the 2 small
duct cover screws provided.
Lower
filter slots
■ Install all three metal grease filters.
■ Turn power on. If the filter light on the control panel
glows, adjust the right-side filter in the channel to
engage the switch arm.
■ Be sure fan and lights operate correctly. Refer to
the Owner's Manual for operating instructions and
Problem Solver.
658Dia27
13