Step 4, Assemble Deflector And Connector; Step 5, Size Duct Piece; Step 6, Install Air Deflector Assembly - Monogram ZV750 Instrucciones De Instalación

INSTALLATION – RECIRCULATING
4
ASSEMBLE DEFLECTOR
AND CONNECTOR
A. The duct connector is shipped
inside the deflector.
B. Snap the plastic connector out
of the deflector and remove.
C. Turn over the plastic
connector. From the bottom,
snap the connector over the
opening as shown.
B
Remove plastic connector
5
SIZE DUCT PIECE
■ Hold air deflector
with duct connector
against the ceiling.
Align window on
the back of the
deflector with the
Centerline
marked centerline.
■ Measure from
the bottom of the
deflector to the
top of the hood as
shown. Reduce
this dimension
by 1" to facilitate installation.
The duct will cover/overlap
the duct connector and the
exhaust outlet.
■ Cut the duct piece to size and
slip onto the bottom of the
duct connector.
■ Use duct tape to secure the
duct piece to the connector.
■ Temporarily install the 2 small
duct cover screws into the
sides of the deflector. Remove the screws. This will
ensure ease of final installation.
16
Installation Instructions
A
C
Snap into place
Duct
length
Measure
length
Screws
Air deflector assembly
6
INSTALL AIR DEFLECTOR
ASSEMBLY
■ Place the assembly
over the hood outlet.
■ Hold the assembly
against the ceiling.
The penciled
centerline should
show through the
slot on the deflector.
Mark the two screw
holes on the back of
the assembly.
■ Remove the
assembly and drill
1/8" pilot holes into
the wall studs.
■ Enlarge holes that
did not enter studs to 3/8" and tap plastic or metal
anchors into the holes, flush with the wall.
■ Mount the assembly onto the hood outlet, push up
against the ceiling and install the screws provided.
■ Use duct tape to seal the connection.
CAUTION
Do not use sheet metal screws at
the hood duct flange connection. Doing so will prevent
proper damper operation. Seal connections with tape
only.
31-10724-7