Install Hood Mounting Screws; Install Duct Bracket - Monogram ZV830 Instrucciones De Instalación

Ocultar thumbs Ver también para ZV830:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION—VENTED TO THE OUTSIDE
2
INSTALL HOOD MOUNTING
SCREWS
The two upper mounting screws must enter the
horizontal support or wall studs.
mark mounting bracket screw locations.
the lower bracket.
between the screw head and the wall. This will
allow the keyhole slot on the hood frame to engage
the screw head.
1-1/4"
10-1/16"
TOP
MOUNTING
NOTE: Top
mounting
HOLE
screws MUST
DRILL 1/8"
engage wood
PILOT HOLE
support.
9-7/16"
15-7/16"
BOTTOM
MOUNTING
HOLE
Installation Height
Align Bottom Edge With
Pencil Line Indicating
Bottom of Hood
IMPORTANT: Use the mounting screws provided. DO
horizontally level.
3

INSTALL DUCT BRACKET

The duct bracket should be installed against the back
wall and flush with the ceiling. This bracket will hold
the duct cover in place at the top.
Secure the bracket to the wall:
with the penciled centerline on the wall.
(provided).
install per the fastener supplier's instructions.
the screws.
wall with wood screws
and/or fasteners.
Installation Instructions
1-1/4"
TOP
MOUNTING
NOTE: Top
HOLE
mounting
DRILL 1/8"
screws MUST
engage wood
PILOT HOLE
support.
REAR WALL
MOUNTING TEMPLATE
15-7/16"
9-7/16"
C L
BOTTOM
MOUNTING
HOLE
Installation Height
Align Bottom Edge With
Pencil Line Indicating
Bottom of Hood
Centerline
cutout
4
MOUNT THE HOOD
WARNING
2 people are required to lift and
position the hood onto the mounting screws.
the wall.
Tighten
screws
Install
screws
49-80512 Rev. 4

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Zv830sm1ssMoreradwrh2051Zv830sm2ss

Tabla de contenido