Project Source 252-K825-PS-SSD Manual Del Usuario página 4

ASSEMBLY INSTRUCTIONS
1. Turn off water at the supply valve at the main water supply,
disconnect the supply lines, and remove old faucet body.
Clean and dry surface area where new faucet will be mounted.
2. Place new faucet (A) through holes in top of the sink. From
underside, slided mounting nuts (AA) onto threaded rods.
Secure with mounting nuts (AA).
Hardware Used
Mounting nut
AA
3. Plug the quick connector cover (3.3) into the faucet body adapter
(3.2). Push all the way to the top. Pull down the hose (3.1) to lock
up quick connector. Check the security of the quick connector by
pulling the hose up and down.
4. Attach weight (B) to hose where indicated in drawing (4.1).
Once weight is firmly attached, pull the spray head (4.2) in and
out to check for smooth operation.
5. Connect Water Supply Lines
Use 1/2 in. IPS faucet supply lines (5.1) or use coupling nuts (5.2)
(not supplied) with ball-nose risers (5.3) (not included).
Turn water supply or shut-off valve back on and check for leaks.
If leaks occur, gently tighten the faucet connections.
x 2
4
1
2
A
AA
AA
3
A
3.2
3.3
3.1
4
4.2
4.1
B
5
1
5.1
Lowes.com
3
5.3
2
5.2