Releasing The Vdo-Testdata - Bosch 1 687 010 193 Manual Original

Juego de accesorios para bombas de alta presión vdo common rail
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 52
en
en
28 | 1 687 010 193 / 1 687 016 193 | Initial commissioning
4.3.1
Installing the "EPS945" software
i
If the latest software is already installed on the EPS,
you can continue from the section 4.3.2.
i
The installation of the software is described in
the program description EP software (order no:
1 689 989 099) in section 3.3 "Installation of the
KMA software EPS 945".
1. Connect the EPS 815 to the mains voltage.
2. Switch on the EPS 815 at the master switch.
3. Install the "EPS945" software (see program
description 1 689 989 099).
"
This completes installation of the "EPS945" software.
4.3.2
Installing the "EPS945-VDO" software
1. Close all running applications.
2. Install the "EPS945-VDO" software as described in
the section 4.3.1.
"
This completes installation of the "EPS945-VDO"
software.
4.3.3
Installing CD-TestData
1. Close all running applications.
2. Insert the CD-TestData 1 687 370 270 in the CD/
DVD drive. The dialog box "Select setup language" is
displayed after a few seconds.
3. Select a language (e.g. "German" for Germany).
4. Confirm selection with <OK>.
 The start screen appears.
5. Heed the information on the start screen and press
<Continue> to proceed with installation.
 The selection menu for the databases is dis-
played.
6. Select the databases "EPS945 – TestData" and
"VDO – TestData".
7. Press <Continue> to proceed with installation.
|
1 689 989 337
2017-06-15
i
Depending on the software version, software
updates (patch files) are also installed. Confirm
messages with <Ok>. Under certain circumstances,
the firmware may need to be updated (see online
help "EPS945-VDO").
8. Heed the information in the dialog box and press
<Install> to continue with installation.
 Database installation is started. Following instal-
lation, a dialog box appears.
9. End installation with <Complete>.
"
This completes database installation.
4.4

Releasing the VDO-TestData

i
It is necessary to release the VDO – TestData
(database with VDO components). The customer
number and release code are available from your
VDO regional subsidiary (RSO) or your dealer.
i
For further information, see the "EPS945-VDO"
online help.
1. Start the "EPS945-VDO" software.
 The start screen is displayed.
2. Press <F12>.
 The "Component selection" window is displayed.
3. Press <F2>.
 The "Release" window is displayed.
4. Enter the VDO customer number and release code.
5. Press <F4>.
 The remaining operating time of the VDO-TestDa-
ta is updated.
6. Save and continue with <12>.
Robert Bosch GmbH

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

1 687 016 193

Tabla de contenido