Leviton MSTCT-2SC Manual Del Usuario E Instalación página 17

1.800.561.8187
4 GENERAL METERING FEATURES AND FUNCTIONALITY
LCD
Error Meter
Error
Category Status
Message
None NORMAL None
Low
Warning None
Current
Reverse Err rC1 or
Installation
Energy Err rC2
Bad
Err PF1 or
Installation Power
Err PF2
Factor
Low Err LU1 or
Installation
Voltage Err LU2
Err HU1
Over
Installation or Err
Voltage
HU2
Err HC1
Over
Installation or Err
Current
HC2
Factory FAIL 01
Failure Service FAIL 02 ...
Required FAIL 05
Table 7 - LCD Indications
While in a failure condition, in addition to displaying a "FAIL" code on the error screen the
screen ID (leftmost digit) on every screen blinks, alternating between the screen ID and the
character "F".
For a single-element meter, no errors are reported on line 2.
If the meter reports an installation error, refer to Section 6 for troubleshooting. If the meter
reports a failure condition, contact Leviton technical assistance.
www.
L1/L2 Determination of
Bar/Arrow
Symbols Error Condition
Animated arrow No error or warning
Both off
pointing right
Bar and arrow Blinking Power greater than
indicators turned (one or or equal to -15W but
off both) less than +15W.
Blinking
Arrow pointing Power less than
(one or
left (no blink)
both)
Checked only when
current is greater
Solid bar (no Blinking than starting current
blink), no arrow (one or level. Error when
either side both) phase angle is
greater than 80°
and less than 90°.
Solid bar (no Blinking
blink), no arrow (one or Voltage below 102V.
either side both)
Solid bar (no Blinking
Voltage above
blink), no arrow (one or
either side both)
Current above 110A
Solid bar (no Blinking if configured for
blink), no arrow (one or 100A CT or 220A if
either side both) configured for 200A
Blinking bar, no Operational error
Both off
arrow either side
15
information@itm.com
.com
conditions.
-15W.
138V.
CT.
detected.