Flex WS1505FR Instrucciones De Funcionamiento página 12

n Do not work in rooms which contain an
explosive atmosphere.
n Ensure that you have a firm footing,
especially on scaffolding.
n Check diamond wheel before use; use
undamaged diamond wheels and
clamping nuts only.
n The borehole in the diamond sheet must
fit on the output shaft without play or
pretension. Do not use reducers or
adapters.
n The attached diamond wheel must
rotate freely.
n After clamping on the tool, always
conduct a 30-second test run on an
idling machine. While conducting this
test run, keep out of the danger zone.
If the machine vibrates violently, switch
off and check the machine immediately.
Do not use diamond wheels which are
severely out-of-balance.
n Do not strike or knock diamond wheels.
n Always hold the machine in such a way
that it cannot strike against the user if
the diamond wheel locks.
n Do not damage the outer skin of the
drive motor, otherwise electrical safety is
no longer guaranteed.
n Immediately replace damaged power
cords and plugs.
n Caution when changing tool, diamond
wheel may be hot.
12
Long-necked renovation sander WS 1505FR
n During renovation work, there is a risk of
particles flying out in an uncontrolled
manner; therefore, keep people out of
the way.
n Due to the high noise level generated
during work, any hazardous situations
are not immediately noticeable,
therefore safeguard the work area.
n When handling the machine, ensure that
work clothes cannot become caught.
n To prevent people from tripping, ensure
that there is adequate lighting and that
the work area is safe and tidy.
n Always place the machine securely to
prevent it from falling down, e.g. from
scaffolding and ensure that the ON/OFF
switch is not actuated unintentionally.
n When the machine is switched off, the
diamond wheel continues running
briefly.
n To prevent trapping your hand, do not
hold the machine at the front by the
swivel-mounted sanding head.
n Hidden objects which are exposed
during sanding may block the diamond
wheel and cause the machine to move
to the side. If the diamond wheel jams,
switch off the machine immediately.
n Before carrying out any work on the
power tool, always pull out the mains
plug.