SERVICE
Lubrication
The axle bearings and the side rod bearings should be lubricated occasionally with a
small amount of Märklin-Oil (7149).
Replacing the light bulbs (E130 023)
Lights (front, upper rear): Pull the lantern housing away from the model. Remove and
replace the bulb. Reassemble.
Lights (lower rear): Remove the ring around the lantern lens. Carefully pry the lens
away from the lantern. Using tweezers, remove and replace the bulb. Reassemble.
Cab light: Using tweezers, remove and replace the bulb.
Replacing the traction tire
- Remove the screw in front of the rear gearbox.
- Remove the screw on the rear coupler.
- Remove the hex screw on the rear drive rod and take the drive rod off the wheel.
- Pull the rear gearbox out of the sideframe.
- Use a small, straight-blade screwdriver to pry the old traction tire out of the wheel
groove.
- Use a small, straight-blade screwdriver to gently pry the new traction tire into the
wheel groove.
- Make sure that the traction tire is seated properly in the wheel groove.
- Reassemble.
Controllable Functions
Lighting
1
Sound effect: Long whistle blast
Sound effect: Squealing brakes off
Sound effect: Bell
Sound effect: Announcement
Sound effect: Coal being shoveled
Sound effect: Operating sounds
1
Smoke generator
Sound on/off
ABV, off
Engineer's cab lighting
Sound effect: Departure whistle
Double A switching light
Sound effect: Conductor whistle
Sound effect: Short whistle blast
Sound effect: Blowing off steam
Sound effect: Sanding
Sound effect: Announcement
Sound effect: Announcement
Sound effect: Letting off air
Sound effect: Cab conversation
Sound effect: Cab conversation
Sound effect: Coupling together (buffer to buffer)
1
active in analog operation
2
with random sounds
10
1, 2
LV + LR
1
Sound 1
2
BS
3
Sound 3
4
Sound 4
5
Sound 9
6
FS
7
SUSI F7
8
9
10
AUX 3
11
Sound 14
12
LV + LR
13
Sound13
14
Sound 2
15
Sound 15
16
Sound 16
17
Sound 5
18
Sound 6
19
Sound 11
20
Sound 20
21
Sound 21
22
Sound 17