Maclaren quest Manual De Usario página 12

EN
Instructions
• READ THESE INSTRUCTIONS CAREFULLY BEFORE USE AND KEEP THEM FOR FUTURE REFERENCE.
IMPORTANT:
• YOUR CHILDREN'S SAFETY MAY BE AFFECTED IF YOU DO NOT FOLLOW THESE INSTRUCTIONS.
1 TO OPEN THE BUGGY
A Release storage clip.
B Open out the buggy.
C Using foot, push the footplate down fully to engage
the primary locks.
CAUTION: Ensure that all locking devices are engaged before use.
2 TO OPERATE BRAKES
Locate the brake lever at the back of the buggy frame.
A TO ENGAGE BRAKES: With foot, press down on the left side of the pedal.
B TO RELEASE BRAKES: With foot, press down on the right side of the pedal.
CAUTION: Parking device shall be engaged during the loading and unloading of
children.
CAUTION: Ensure parking device is engaged before leaving the buggy
unattended
3 TO OPERATE FRONT WHEEL SWIVEL LOCKS
A TO LOCK SWIVELS: Align front wheels and press down on locking levers.
B TO UNLOCK SWIVELS: Raise locking levers.
4 SEAT BELT/SHOULDER HARNESS OPERATION
WARNING:
AVOID SERIOUS INJURY FROM FALLING OR
SLIDING OUT.
ALWAYS USE SEAT BELT.
TO FIT HARNESS:
A Pull shoulder straps over the childs shoulder then attach to the waist
clips by sliding strap loops onto the hooks.
B Insert both waist clips into the clasp, shoulder straps are secured once
the clips are fastened.
C Adjust strap lengths by sliding buckles. Belt and harness should be snug.
TO RELEASE HARNESS:
D Press the button on both the front and back of the clasp simultaneously
to release.
5 TO ADJUST SEAT RECLINE
A TO RECLINE SEAT BACK: Lift both hand grips to release seat locks and
slide the seat back to desired position. Lower hand grips to engage locks
on both sides.
B TO RAISE SEAT BACK: From rear of buggy push seat back to original
upright or desired intermediate position.
6 TO OPERATE THE LEGREST
TO EXTEND THE LEGREST: Feel through seat corner openings. Locate sliders
and pull forward.
Reverse this process to retract legrest.
7 TO FIT THE SHOPPING BAG
CAUTION: Overloading may cause a hazardous unstable condition to exist.
Maximum load 4.4 lb (2 kg) evenly distributed.
The buggy may be folded with the bag still attached but all contents must
be removed. Failure to do this could damage buggy and contents of
shopping bag.
A Place bag on the 'X' frame under seat with lowest edge of bag at front.
B Attach front straps to front legs just below seat.
C Attach rear straps to rear legs just above horizontal tie bar.
8 TO ATTACH THE HOOD
CAUTION: Overloading may cause a hazardous unstable condition to exist.
Maximum total capacity of hood pocket (if fitted) - 1.1lb (0.5 kg).
A Slide left hand and right hand pivot blocks DOWN over the retainers
located on the handle tubes.
B Place rear apron behind seat back.
C Extend hood and press down on side hinges to lock open.
9 TO FIT THE RAIN APRON
A Place the apron over the hood front.
B Attach two eyelets (one each side) to the hood clips.
C Attach the two eyelets (one each side) to the front legs.
10 REMOVING AND REFITTING THE SEAT COVER
Remove hood from buggy if fitted.
A Twist shoulder strap end buckles and feed through holes.
B Feed waist and crotch straps through holes.
C Unclip seat cover retaining straps.
D Unfasten seat fabric from handle tubes and seat base.
E Slide fabric from seat back and base.
F When refitting seat fabric, insert seat back support tubes
into fabric slits.
G When refitting seat fabric to seat base, loop fabric flap over legrest strap
and pass crotch strap buckle through both holes in seat fabric and then
hole in seat base.
H When refitting shoulder straps, twist buckles and feed through holes.
11 TO REMOVE THE CARRY STRAP
A Release the primary lock and secondary lock.
B Press clip release and remove clip from 'D' ring.
C Slide strap loops from handles.
D Using foot, push the brake pedal down fully to engage the primary lock.
12 TO FOLD THE BUGGY
Ensure the seat back is in its fullest upright position and the hood(if fitted) is
folded back. Remove contents of shopping bag.
It is recommended that the harness is fastened before folding the buggy.
A Using foot, lift up on brake pedal to release primary lock.
B Push down on secondary lock lever.
C Grip handles and push forward on buggy.
D Compress folded buggy and engage storage clip.
3