Installation Instructions - Festo CPX-CP-4-FB Manual Del Usuario

3

Installation instructions

3.1 Fitting
The CPX−CP interface is mounted in a manifold sub−base of
the CPX terminal.
1
Screws, tightening
torque 0.9 ... 1.1 Nm
2
CPX−CP interface
3
Contact rails
4
Manifold sub−base
(as you like, here
with an additional
supply, for instance)
Dismantling:
Remove the screws and lift the CPX−CP interface up
S
carefully.
Fitting:
1. Check the seal and sealing surfaces and refit the
CPX−CP interface.
2. Screws must be inserted so that the self−boring
threads can be used. Tighten the screws in diagonally
opposite sequence at first by hand (Torx T10). Tighten
ing torque 0.9 ... 1.1 Nm.
Festo CPX−CP−4−FB xxxxNH English
1
2
3
4
13