Festo CPX-CP-4-FB Manual Del Usuario página 16

CPX field bus node/CPX−FEC
CPX field bus nodes or CPX−FEC
with Remote I/O operating
mode:
System parameter System
start" ( [System start] ):
System start with default
parameterisation and current
CPX equipment status"
( [Default parameters] ),
factory setting
CPX field bus nodes or CPX−FEC
with Remote I/O operating
mode:
System parameter System
start" ( [System start] ):
System start with saved para
meterisation and saved CPX
equipment status" ( [Saved
parameters] )
CPX−FEC with Stand Alone or
Remote Controller operating
mode
16
Accepting the address range
The modified address range of the
CPX−CP interface is automatically
accepted.
1. Change system parameter
System start..." to ... Default
parameterisation ...".
2. Switch the power supply of the
CPX terminal off and back on.
This automatically accepts the
modified address range of the
CPX−CP interface.
3. If necessary, you can restore
the desired parameterisation.
S To accept the address range of
the CPX−CP interface, the actual
configuration must be saved as
the set configuration (actual−
nominal comparison). You will
find information on this in the
manual for the CPX−FEC or for
the software package FST 4.1.
Festo CPX−CP−4−FB xxxxNH English