Worx WG117 Manual Del Usuario página 11

AssEMBLY
1. aSSEMBly oF THE SaFETy GuaRd
(See Fig. a)
Remove the screw from the safety Guard (4)
and fit the guard to the trimmer head; align
the guard so it slides into the slots located
on the trimmer head. Turn the tool over and
secure the safety Guard onto the trimmer
head with the screw (a) provided.
2. aSSEMBly oF THE EdGER wHEEl
(See Fig. B)
With the tool right side up, slide the edger
Wheel (8) assembly onto the metal plate
located on the side of the trimmer head. Make
sure the grooves of the edger Wheel assembly
lock onto the metal plate; you will hear it click
into place.
To remove the wheel assembly, press the
release button (b) on the wheel and pull the
wheel assembly upward.
3. FITTING THE auxIlIaRy HaNdlE
(See Fig. C1,C2)
NoTE: THE auxIlIaRy HaNdlE MuST
BE aTTaCHEd to the trimmer shaft
before use.
waRNING: To avoid injury, alwayS
turn off and disconnect the
trimmer from the power outlet BEFoRE
installing parts or cleaning the trimmer
or making any adjustments.
1) Disconnect the trimmer from the power
supply.
2) Unscrew the auxiliary handle's tightening
knob (counter-clockwise) and remove from
handle.
3) Position auxiliary handle onto handle
bracket assembly located on trimmer's top-
shaft (see Fig. C1).
4) Position the knob and screw through the
auxiliary handle and bracket, and tighten
knob (turn clockwise). (see Fig. C2) Do not
tighten completely until you have adjusted
the auxiliary handle to your desired working
position.
2-in-1 Grass Trimmer/Edger
oPErATING INsTrUCTIoNs
waRNING: The cutting head
continues to rotate after the
trimmer has been switched off. wait
until it stops before laying the trimmer
down.
always wear eye protection. Never
•
lean over the trimmer head. Rocks or
debris can ricochet or be thrown into
the eyes and face and cause blindness
or other serious injury.
Hold front handle with one hand and
•
auxiliary handle with the other hand.
keep unit below waist level. work
only from your right to your left to
ensure debris is thrown away from
you. without bending over, keep
line near and parallel to the ground
(perpendicular when edging) and not
crowded into material being cut.
Before operating, make sure both
•
trimmer lines are extended. when
trimming, make sure motor is running
at full speed.
use only 0.065"(1.65mm) diameter
•
cutting line. other line sizes will not
properly feed in the trimmer head and
could cause serious injury. Never use
other materials such as wires, string
or rope, as this may break off during
cutting and cause serious injury.
1. FlowER GuaRd (See Fig. d)
Push the Flower Guard (5) in when edging and
pull it out before trimming, as shown in Fig
D. Before trimming or edging make sure the
Flower Guard is locked firmly in position.
2. adJuSTMENT oF THE TElESCoPIC
SHaFT (See Fig. E1,E2)
Unscrew the Locking Collar (3) clockwise to
unlock, as indicated. Adjust the length of the
Telescopic shaft (6) to the most comfortable
length (see Fig. e1). Tighten the Locking
Collar counter-clockwise to lock, as indicated
(see Fig. e2).
3. MaIN HaNdlE RoTaTIoN
(See Fig. E3,E4)
First, hold down the lower housing with your
11
EN