Worx WG117 Manual Del Usuario página 13

12. REMovING THE CaP
Press and hold in the two Cap Release Latches
(11) (see Fig. K).
Pull the Cutting Head Cover (10) away from
the Cutting Head (13). Keep the Cutting Head
Cover and the inside of the Cutting Head clean
from debris. To replace the Cutting Head
Cover, press it firmly onto the spool holder.
ensure that it is correctly connected by trying
to remove it without depressing the two Cap
Release Latches.
13. CHaNGING THE lINE SPool
First take off the Cutting Head Cover (10) and
remove the old spool (12). Place the new
spool onto the Cutting Head (13). Feed one
line through the eyelet (14), and then repeat
for the second line. Reattach the Cutting Head
Cover.
waRNING! your Trimmer is
designed to only use line with a
maximum diameter of 0.065" (1.65mm).
only use nylon line.
IMPoRTaNT - always wind the line onto
the upper section of the spool first.
14. To MaNually wINd lINE
Take approximately16ft (5m) of line and insert
5/8" (15mm) of line into one of the holes in the
upper section of the spool (12) (see Fig. L1).
Wind the line in the direction of the arrows
on the top of the spool. Repeat process with
separate piece of line on lower section of
spool (see Fig. L2&L3).
Leave approximately 4" (100mm) of line
unwound and place it into the cleat. Repeat on
the lower section of the spool.
Care should be taken to ensure that the line
is neatly coiled on the spool (see Fig. L4).
Failure to do so will impair the efficiency of the
automatic line feed.
Then fit the spool as described above in
"Changing the line Spool".
2-in-1 Grass Trimmer/Edger
MAINTENANCE
After use, disconnect the machine from
the electrical outlet and check for damage.
Your trimmer requires no additional
lubrication or maintenance. There are no user
serviceable parts in your trimmer. electric
powered trimmers should only be repaired
by an authorized repairer. Use only WORX
replacement parts and accessories.
Never use water or chemical cleaners to clean
your trimmer. Wipe clean with a dry cloth.
Always store your trimmer in a dry place
out of the reach of children. Keep the motor
ventilation slots clean. If you see some sparks
flashing in the ventilation slots, this is normal
and will not damage your trimmer.
13
EN