Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
LEVER AND SWITCH
SELECTION OF WORKING SOLVENT
Upward, horizontal: clean solvent. (not recycled solvent), can
work in automatic with timer and make a manual pump by
pressing LOWER BUTTON.
The safety devices should always be in an optimal
state and should not be removed.
- Disconnect the compressed air supply in case of
repairs or maintenance.
- Periodically check the integrity and functionality
of safety devices.
- Periodically clean the discharge area, cleaning
area, and control valves.
- Clean and replace the pump suction filter.
The ordinary maintenance operations must be
carried out only by qualified personnel following
the instructions in this manual. Always cut the air
supply for maintenance or repair.
Ordinary maintenance operations are:
- Clean the working area, grid and discharge.
- Always maintain adequate levels of solvent in
each of the two tanks.
- Check and maintain clean the suction pump filter.
- Maintaining an adequate level cleaning of the
recirculation solvent. Change before accumulating
excess waste and lost washing effectiveness. Once
We recommend using the button for a few
seconds, just time for this operation, thereby
avoiding too fast clean solvent consumption.
Open and take out the spray gun and accessories.
At this point the aspiration of fumes will always
be operating.
If appropriate you can use the blow gun to
evaporate and totally dry spray gun and
accessories.
Once the operation is finished close the lid of the
washing area. Always place the solvent leaber
selector upright.
13. SAFETY DEVICES
- The safety labels must always be clearly visible,
clean and immediately replaced in case of
damage.
- It is absolutely forbidden to perform operations
with the equipment when all labels are not clearly
visible.
14. MAINTENANCE
the solvent substituted, the treatment of this should
follow the applicable regulations.
- Check for proper operation the safety devices
and operating controls.
Do the internal cleaning of the machine weekly.
Internal cleaning of the machine is done by using
a suitable solvent.
Do the cleaning of jets every three weeks.
Disassemble and immerse then in a clean solvent
for about 1 hour. Wash with clean solvent from
about 1 minute to wash the pipes. Place the
injectors clean.
- 18 -
WARNING
THE EQUIPMENT ALWAYS MUST
BE CONNECTED TO GROUND.
Publicidad
Tabla de contenido
