Publicidad
Idiomas disponibles
Idiomas disponibles
Introduction
The MAXAMP is designed for charging and discharging NiCD and NiMH batteries consi-
sting of 1 to 30 cells. The maximum charge current is 12 A, the maximum discharge current
22 A.
The following functions are available: CHARGE, DISCHARGE, multiple DISCHARGE-
BEFORE-CHARGE and multiple CHARGE-BEFORE-DISCHARGE.
Safety notes
·
If the charger is not to be used for a protracted period, disconnect it from the power
source and remove any battery packs connected to it.
·
Be sure to keep the cooling slots unobstructed to provide good air circulation - don't
stand the charger on a carpet or felt surface.
·
Unfold the feet fitted to the underside of the charger.
·
Do not set up the charger and batteries on a flammable surface, and never leave the
unit operating unsupervised.
·
Protect the unit from damp.
·
Take care to maintain correct polarity at all connections and outputs.
·
Avoid short-circuits.
·
Don't subject the charger to direct sunshine, and do not cover it.
·
Do not charge batteries which are already hot; allow them to cool down to ambient tem-
perature before recharging.
·
Use only packs of fast-charge cells which have been properly balanced (equal state of
charge).
·
Packs must consist of cells of the same make, type and capacity.
·
Do not wire two packs together in parallel for charging.
·
The unit is only suitable for use with rechargeable batteries.
·
Set charge currents within the maximum rated capacity of the cables and connectors
attached to the battery pack.
·
Never connect any charger output to the input.
Specification
Operating voltage:
Current drain:
Nominal battery voltage:
Charge current:
Voltage:
0V ... 18V
Max. current:
12A
Automatic charge termination: Delta Peak process and/or temperature monitoring
Trickle charge:
Discharge current:
Voltage:
0.1V ... 9V
Max. current:
22A
Operating instructions
POWER PEAK MAXAMP
approx. 10 V ... 15 V DC
high-performance 12 V lead-acid battery or a powerful well
stabilised mains PSU (do not use a car battery charger!)
max. approx. 40 A!
1.2 V ... 36.0 V (1 ... 30 NiCD / NiMH cells)
0.1 A ... 12 A
18V ... 27V
27V ... 36V
8A
none
0.1 A ... 22 A
9V ... 13V 13V ... 18V 18V ... 28V 28V ... 40V 40V ... 50V
15A
11A
10
36V ... 45V
6A
5A
7A
Order No.
8121
Over 45V
4A
5A
4A
Publicidad
