Beurer MP 60 Instrucciones Para El Uso página 8

right (clockwise running). The two buttons marked with plus (+) and minus (-) allow you to se-
lect the speed of rotation. Start every application at low speed and increase it only as required.
– All file and cutting attachments are coated with a sapphire grain. This guarantees extremely
long life and almost guarantees freedom from wear.
– Do not exert heavy pressure and always guide the attachments carefully over the surface to be
treated.
– Move the instrument under light pressure in circular movements slowly over the parts to be
treated.
– Note that the cutting attachments will have a reduced effect if the skin is softened or moist.
For this reason, do not carry out any pretreatment in a bath.
– Do not remove all the callus skin in order to retain the natural protection of the skin.
– Always ensure that the spindle can rotate freely. It must never be permanently jammed, other-
wise the instrument will become too hot and suffer damage.
– After every use, apply moisturizing cream to the parts treated.
!
Important:
Check the results during treatment. This is particularly important for diabetics, since
their hands and feet are less sensitive.
3.2 Attachments
The following three attachments are included in the basic equipment:
With the upgrade Profiset you have six additional attachments available:
Since these involve Profi attachments, we would ask you to proceed with caution when using
the additional attachments, since incorrect use could lead to injury. Exercise particular caution
at higher speeds.
A – Sapphire cone
Removal of dry skin or calluses from the soles of the feet and from the
heels and for manicuring the nails.
B – Felt cone
Smoothing and polishing the edge of the nail after filing as well as for
cleaning the nail surface. Always polish in circular movements and do not
allow the felt cone to rest in one place, otherwise friction could cause heat
to develop.
C – Sapphire disk, fine
Filing and treatment of the nails, fine grained sapphire disk.
The specific aspect of this sapphire disk is that only the inner disk rotates,
while the outer support is stationary. This enables precise filing of the nails
without the risk of burning the skin with the fast rotating disk.
D – Cylindrical milling cutter
Grinding of lignified foot nail surfaces as well as smoothing of these. For
this purpose, apply the milling cutter horizontally to the nail surface and
remove the unwanted layer of nail using slow circular movements.
8