GYS M1 auto Manual De Usario página 15

choice oF reels
possible settings:
Torche 1
type fil
T1,T2,T3,M1
acier
Ø 300
x
Ø 200 x
Ø 100
Ø 200
inox x
Ø 100
Ø 200
CuSi3 x
Ø 200
CuAl8 x
Ø 300
Alu x*
AG5
Ø 200 x*
AlSi5
Ø 100
AlSi12
Ø 100
CuSi3: Recommandation OPEL & MERCEDES
CuAl8: Recommandation Peugeot/Citroën/Renault
AlSi12: Recommendation for automotive aluminium from metal sheet of 0,6mm to 1,5 mm of thickness.
* Consider Teflon sheath and special aluminium contact tip
«Manual» Mode (FiG 5)
1-welding mode choice:
- Normal (2T): standard two-stage welding
- Delay: intermittent welding modes for an optimised
operating procedure.
- Spot:spotwelding with ajustable spot diameter
2- Wire speed settings: wire speed fitting potentiometer.
The speed varies from 1 to 15L/minute.
3- Spot/delay potentiometer fitting
4- Manual mode: In manual mode, the wire speed is
determinated by the user by adjusting the potentiometer
(2).
«Manual» Mode (FiG 5)
To set your device, proceed as follow:
- Choose the welding voltage using the 7 positions switch
Example: position 1 for 0,6mm metal sheets and position 7 for 4 mm metal sheets.
- Adjust the wire speed with the potentiometer(2).
Advice:
The wire speed adjustment is often determinated « with the noise »: the arc must be stable and have a
low crackling. If the speed is too low, the arc is not continuous. If the speed is too high, the arc crackles
and the wire pushes back the torch.
M1 - T1 - T2 eT T3 GYs auTo
Gaz
Torche 2 Spool gun
T2,T3 T2,T3
x
argon
+
x
CO2
x
x
x
x
argon
x*
pur
x
x
5- Synergic mode: position the potentiometer (2) in the
middle of the «optimal synergic» zone. In this mode, the
device determines the optimal wire speed according to 3
parameters:
- Voltage
- Wire diameter
- The power mode.
It's possible to adjust the wire speed +/-.
In position Normal(2T), 2 modes are proposed to ease
the settings of the device: Manual or Synergic.
en
15