PEERLESS Paramount PSP2 Instalación Y Montaje página 4

2-1
Single Keyhole Mounting
Insert 8-32 x 5/8" phillips screw (F) and washer (Q) through the single hole mounting plate (B) and thread the 8-32 round
key hole nut (J) a few turns onto the 8-32 x 5/8" phillips screw as shown in fi gure 2.1 and fi gure 2.2. Be certain beveled
edges of round key hole nut face mounting plate. Do not fully secure 8-32 round key hole nut at this time. Insert 8-32
round key hole nut into the key hole slot of speaker and slide upward into narrow end of key hole as shown in fi gure 2.3.
Secure mounting plate to speaker by gently pulling back on mounting plate and tighten 8-32 x 5/8" phillips screw.
J
fi g. 2.1
B
2-2
Two-hole or Four-hole Mounting
Attach double hole mounting plate (A) to speaker
using two 1/4-20 x 1/2" screws (K) as shown in
fi gure 2.4. Four-hole speaker mount patterns can
be accommodated by positioning the mounting
plate diagonally as shown in fi gure 2.5.
2-3
Self-Tapped Mounting
Position double hole mounting plate (A) on back of
speaker in mounting location and use it as a template to
mark center of holes. Drill two pilot 1/8" (3 mm) dia. holes
.5" (12 mm) deep. Do not drill deeper than .5".
CAUTION
• Do not drill or screw into the speaker where you
could possibly damage the internal components. If
unsure of location of internal components, check
specifi cations with manufacturer of the speaker.
Secure mounting plate to speaker with two #12 x 3/4" self
tapping screws (M).
Visit the Peerless Web Site at www.peerlessmounts.com
If 8-32 x 5/8" screw does not
fully secure mounting plate
to speaker,
spacer (I) can be used.
BEVELED
EDGES
F
Q
J
F
fi g. 2.4
I
B
fi g. 2.2
SPEAKER
A
4 of 18
For customer care call 1-800-729-0307 or 708-865-8870.
SPEAKER
J
fi g. 2.3
A
K
SPEAKER
fi g. 2.5
SPEAKER
A
ISSUED:10-23-07 SHEET #: 087-9016-4 02-12-18
B
M