Quick Installation; All Models - Tripp-Lite SmartOnline SUINT1000XL Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

200607207 93-2525 230V Smartonline OM.qxd

Quick Installation

Connection and Start-Up
Plug your UPS into an electrical outlet.
1
Note: The UPS system does not include an input power cord.
1A
Model SUINT1000XL Only:
Connect a user-supplied power cord to the IEC-
320-C14 input receptacle. The power cord
should have an IEC-320-C13 connector on one
end and a plug appropriate for your local site's
utility outlets on the other end.
1B
Models SUINT2000XL and SUINT3000XL
Only:
Connect a user-supplied power cord to the IEC-
320-C20 input receptacle. The power cord
should have an IEC-320-C19 connector on one
end and a plug appropriate for your local site's
utility outlets on the other end.

All Models:

Plug the UPS directly into a properly grounded,
3-wire, AC outlet that does not share a circuit
with a heavy electrical load (such as an air con-
ditioner, refrigerator, etc.). The outlet must have
an amp rating equal to or greater than your
UPS's input breaker rating.
Note: Once your UPS is plugged in, the fan and all Indicator
Lights will turn ON. The "LINE" and "LOAD ACTIVE
METER" LEDs will illuminate and the UPS will beep to indi-
cate normal operation. However, power is not supplied to
your UPS's AC outlets until the UPS is turned on.
Plug your equipment into your UPS.
2
Your UPS is designed to support computer
equipment only. You will overload your UPS if
you connect devices with high power demands
such as household appliances or laser printers to
your UPS's outlets.
Note: Additional interconnection cords (C13 to C14) are avail-
able from Tripp Lite. Call 773-869-1234 (Part # P004-006).
Turn your UPS ON:
3
• Press the "ON/TEST" Switch
• Hold it for several seconds until you hear a beep
• Release it
The "ON LINE" LED will now light, and your
UPS will begin providing power to its AC
outlets.
Note: During the initial installation of the UPS, or after
prolonged storage, the internal batteries must charge for 2-4
hours before the UPS can support connected equipment
during a power failure.
11/9/2006
3:51 PM
1A
SUINT1000XL shown
1B
SUINT2000XL shown
2
SUINT2000XL shown
3
SUINT1000XL shown
3
Page 3

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Smartonline suint2000xlSmartonline suint3000xl

Tabla de contenido