Best PIK33 Instrucciones De Instalación página 2

Ocultar thumbs Ver también para PIK33:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING
!
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK OR INJURY TO PERSONS, OBSERVE THE
FOLLOWING:
1.
Use this unit only in the manner intended by the
manufacturer. If you have questions, contact the
manufacturer at the address or telephone number
listed in the warranty.
2.
Before servicing or cleaning unit, switch power off
at service panel and lock service disconnecting
means to prevent power from being switched on
accidentally. When the service disconnecting
means cannot be locked, securely fasten a prominent
warning device, such as a tag, to the service panel.
3.
Installation work and electrical wiring must be done
by qualified personnel in accordance with all
applicable codes and standards, including fire-rated
construction codes and standards.
4.
Sufficient air is needed for proper combustion and
exhausting of gases through the flue (chimney) of
fuel burning equipment to prevent backdrafting.
Follow the heating equipment manufacturer's
guidelines and safety standards such as those
published
by
the
Association (NFPA) and the American Society for
Heating,
Refrigeration
Engineers (ASHRAE) and the local code authorities.
5.
When cutting or drilling into wall or ceiling, do not
damage electrical wiring and other hidden utilities.
6.
Ducted fans must always be vented to the
outdoors.
7.
Do not use this unit with any solid-state speed
control device other than WCPI optional wall
mounted control.
8.
To reduce the risk of fire, use only metal ductwork.
9.
This unit must be grounded.
10.
When applicable local regulations comprise more
restrictive
installation
requirements, the aforementioned requirements
prevail on those of this document and the installer
agrees to conform to these at his own expenses.
TO REDUCE THE RISK OF A RANGE TOP
GREASE FIRE:
a)
Never leave surface units unattended at high
settings. Boilovers cause smoking and greasy
spillovers that may ignite. Heat oils slowly on low or
medium settings.
b)
Always turn hood ON when cooking at high heat or
when flambeing food (i. e.: Crêpes Suzette, Cherries
Jubilee, Peppercorn Beef Flambé.
c)
Clean ventilating fans frequently. Grease should
not be allowed to accumulate on fan or filter.
d)
Use proper pan size. Always use cookware
appropriate for the size of the surface element.
National
Fire
Protection
and
Air
Conditioning
and/or
certification
WARNING
!
TO REDUCE THE RISK OF INJURY TO PERSONS
IN THE EVENT OF A RANGE TOP GREASE FIRE,
OBSERVE THE FOLLOWING*:
1.
SMOTHER
cookie sheet or metal tray, then turn off the
burner. BE CAREFUL TO PREVENT BURNS.
IF THE FLAMES DO NOT GO OUT IMMEDIATELY,
EVACUATE AND CALL THE FIRE DEPARTMENT.
2.
NEVER PICK UP A FLAMING PAN—You may be
burned.
3.
DO NOT USE WATER, including wet dishcloths or
towels—This could cause a violent steam explosion.
4.
Use an extinguisher ONLY if:
A. You own a Class ABC extinguisher and you
know how to operate it.
B. The fire is small and contained in the area
where it started.
C. The fire department has been called.
D. You can fight the fire with your back to an exit.
* Based on "Kitchen Fire Safety Tips" published by NFPA.
CAUTION
1.
For indoor use only.
2.
For general ventilating use only. Do not use to exhaust
hazardous or explosive materials and vapors.
3.
To avoid motor bearing damage and noisy and/or
unbalanced impellers, keep drywall spray, construction
dust, etc. off power unit.
4.
Your insert motor has a thermal overload which will
automatically shut off the motor if it becomes
overheated. The motor will restart when it cools down.
If the motor continues to shut off and restart, have the
insert serviced.
5.
The minimum hood distance above cooktop must not be
less than 24". A maximum of 30" above cooktop is highly
recommended for best capture of cooking impurities.
6.
Two installers are recommended because of the large
size and weight of this unit.
7.
To reduce the risk of fire and to properly exhaust air,
be sure to duct air outside—Do not exhaust air into
spaces within walls or ceiling or into attics, crawl
space or garage.
8.
This product is equipped with a thermostat which may
start blower automatically. To reduce the risk of injury
and to prevent power from being switched on
accidentally, switch power off at service panel and
lock or tag service panel.
9.
Because of the high exhausting capacity of this unit,
you should make sure enough air is entering the
house to replace exhausted air by opening a window
close to or in the kitchen.
10.
To reduce the risk of fire and electrical shock, the Best
models PIK33 and PIK45 must be installed only with
Best interior blower models P5 or P8; Best exterior
models EB6, EB9, EB12 or EB15; Best in-line blowers
models ILB3, ILB6, ILB9 or ILB11. Other blowers
cannot be substituted. (Blowers sold separately).
11.
Use with approved cord-connection kit only.
12.
Please read specification label on product for further
information and requirements.
- 2 -
FLAMES
with
a
close-fitting
lid,

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Pik45

Tabla de contenido