Install Backsplash (Optional) - Best PIK33 Instrucciones De Instalación

3. INSTALL BACKSPLASH (OPTIONAL)

It is recommended to install the backsplash before the custom hood insert. The custom hood will cover the backsplash top mounting
screws. In order to be able to install the backsplash, make sure you have at least 18" clearance between bottom of custom hood and
range control panel or cooktop. (See instructions packed with backsplash.)
4. CUSTOM HOOD PREPARATION
When building a custom hood, always follow all applicable construction codes and standards.
The custom hood frame must be sized to the shape and total weight of the insert assembly. Refer to the table below for total weight of
the insert, according to the type of blower choosen.
I
NSERT MODEL WITH
PIK33
PIK45
Start with the custom hood base, because its position will determine the height of the
insert. We recommend the base of the custom hood should be 3/4-inch thick plywood.
If an optional custom hood liner will be installed, we recommend the sides and front
of the custom hood to be 3/4-inch thick, assuming standard cabinet widths. If the
optional custom hood liner will not be installed, the custom hood side and front thickness
is at the installer's discretion.
Run power cable to installation location. Stub out a 4-foot length of electrical cable
below the custom hood.
If the WCPI optional remote control will be installed, run electrical cable from the
insert to the remote control location. Stub out a 6-inch length from the remote control
wall location. Refer to the remote control installation instruction.
5. SUGGESTED CUSTOM HOOD INTERNAL FRAMEWORK
The mounting holes for the 2 top stud supports are located at 11
insert base. The on center distance between the 2 studs is 30¼" for the PIK33
insert model and 42¼" for the PIK45 insert model.
The mounting holes for the rear stud support are located at 1½" up from the
insert base. See illustration beside.
Once the custom hood base and frame are done, finalize the custom hood.
P5
INTERIOR BLOWER WITH
45
LB
56
LB
WARNING
!
P8
INTERIOR BLOWER WITH
53
LB
64
LB
9 ⁄ " up from the
1 6
1½"
HH0040A
- 6 -
I - E . (
N LINE OR XT BLOWERS ROUGH
31
LB
42
LB
Backsplash
(Optional)
HH0037A
- )
IN PLATE ONLY
Plywood base
thickness: 3/4"
4" for liner
installation
24" to 30" above
cooking surface
Standard 36" h.
cooktop