Best PIK33 Instrucciones De Instalación página 7

6. INSTALL CUSTOM HOOD LINER (OPTIONAL)
The liners are specially designed to protect the exterior base of the custom hood. To order, refer to the table below to find the right liner
model number for your insert and width of custom hood. To view specific model information, including depths for each liner models, visit
www.BestRangeHoods.com or contact Technical support (phone number listed on page 14, in warranty text).
To install, see instruction packed with custom hood liner.
The liner must be installed before the insert.
NOTE: On some liners models, front liner piece may overlap front insert flange. If so, remove the front liner piece, assemble insert,
and reassemble front liner piece.
LINER MODEL
L3336S
L3342S
L4548S
L4554S
L4560S
7. INSTALL THE WCPI REMOTE CONTROL (OPTIONAL)
The electrical connection for the remote control is located in front of the insert.
Perform this connection before the insert installation.
For installation details, see installation instructions included with the WCPI remote
control.
8. CUT THE HOLE IN CUSTOM HOOD BASE
If it is not done yet, cut a hole in the bottom of the cabinet, using the dimensions
shown beside.
INSERT MODEL NUMBER
PIK33
PIK45
NOTES: 1. The notch shown in the inset must be cut only if the WCPI optional
remote control will be installed.
2. The recommended distance from the back to the rearmost cutout edge
is 2¼" minimum.
9. INSTALL BLOWER (INTERIOR OR EXTERIOR BLOWER)
INTERIOR BLOWER : Follow all subsequent steps of this manual.
EXTERIOR BLOWER : Refer to instructions packed with exterior blower and follow steps 13, 14, 16, 17, 19 and up of this manual.
INSERT MODEL CUSTOM HOOD
NOMINAL WIDTH
PIK33 36"
PIK33 42"
PIK45 48"
PIK45 54"
PIK45 60"
A
32½"
44½"
HA0038A
HL0044
17 ¹/
2¼"
min.
HD0084A
- 7 -
3½"
"
16
A
16 ³/ "
8