Kuppersbusch FWKU1870.0X Instrucciones De Uso página 23

Temperature display
To view the set temperature in either zone at any time, touch key H ,display will switch to setting
temperature with one zone flashing and the other one no flashing.
5 seconds later without operation. Then the display turn to current inner temperature again.
NOTE: when first used or after operating the wine cellar after a long period of inactivity, the inner
temperature will not immediately be the temperature shows on the display. Indeed, it is necessary to wait
a few hours for a temperature adjustment of the wine cellar in order to have a homogeneous temperature.
To avoid excessive condensation when the ambient temperature is above 28°C, do not lower the
temperature to below 7°C.
IMPORTANT: after unplugging, turning off the power or after a power failure, it is imperative to
wait 5 minutes before turning it on again.
Temperature alarm
The alarm will sound and the temperature display will flash when:
- The temperature in one of the zones rises or falls outside the temperature range (5-20°C or 5-
20°C)
- You switch the appliance on, if the temperature inside the appliance is very different (+/- 4°C)
from the temperature set after 7 hours working
- Too many items have been put into the unit at one time, and the temperature inside the appliance
is very different (+/- 4°C) from the temperature set after 7 hours working
- The door has not been closed tightly
Door alarm
If the door has been left open for more than 60s, the alarm will sound. Once the set temperature has been
reached in the appliance, the alarm stops and the relevant temperature display stops flashing.
However, if the noise disturbs you, you can switch the alarm off before this if you wish by pressing the
key I once. The alarm will stop. The relevant temperature display continues to flash until the set temperature
has been reached. The display then lights up constantly and the alarm system is fully active again.
Interior light
The interior light makes it easy to view your wines labels and enhances the display of your collection.
Touching the mark (J) toggles between two modes of operation for the internal lights:
- Functional mode (default): the light will turn on only when the door is open, this is the most
economic mode
- Showcase mode: the lights will be on whether or not the door is open. To turn this permanent light
mode and get back the default mode, please push again the light button
Modes
SABBATH MODE
Sabbath mode is available for the observance of certain religious holidays. This mode turns off the
displays, interior light and audible alarms and prevents them from turning on again. Normal cooling
operations will still take place. To initiate sabbath mode, press the power (A) and light (J) keys at the
same time for at least 5 seconds. The indicator light will flash four times and confirm the sabbath mode is
ON. Sabbath mode can be stopped by repeating the above process. The sabbath mode will automatically
exit after 96 hours.
(J).