Suitability For Use - KRATOS SAFETY FA 60 007 00 Manual De Instrucciones

SUITABILITY FOR USE:

The equipment should be used with a fall arrest system as specified in the data sheet (see standard EN363) to guarantee that the dynamic force exerted
on the user during the arrest of a fall is maxi 6 kN. A fall arrest harness (EN361) is the only body gripping device that may be used. It may be dangerous
to create one's own fall arrest system where each safety function can interfere with another safety function. Therefore, it is important to read the
recommendations on using each component in the system before use.
VERIFICATION:
The recommended service life of the equipment is 10 years (in accordance with the annual examination by a competent person authorized by KRATOS
SAFETY), but it may be increased or reduced according to use and/or the results of the annual inspections.
The equipment should be inspected if there is any doubt, or following a fall and at least annually, by the manufacturer or a competent person, and in strict
compliance with the manufacturer's periodic review procedures (particularly Inspection guides ref. GI XX- XXXXXX-XX), to check its strength and
hence the user's safety. The results of the periodic inspection must be recorded in the ENTECH01 inspection report (downloadable from our website).
We recommend that routine inspections are documented using an inspection report and photographs. The "Equipment identification sheet" should be
completed (by writing) after each verification; date of inspection and date of next inspection must be indicated on the "Equipment identification sheet",
it is also recommended to put date of next inspection on the product.
SERVICING AND STORAGE; (Comply strictly with these instructions)
During transport, keep the product in its packaging, well away from any cutting surface; clean it with water, wipe it with a rag and hang it up in a well-
ventilated location, to let it dry naturally and away from a naked flame or heat source; follow the same procedure for components that have become damp
during use. The system must be stored in its packaging in a dry, well aired place protected from extremes of temperature.
7