Installation Location Requirements; Clearances - LG DLHX4072 Serie Manual Del Propietário

Installation location requirements

warnIng
w
Read all installation instructions completely before installing and operating your dryer! It is important that
you review this entire manual before installing and using your dryer. Detailed instructions concerning electrical
connections, gas connections, and exhaust requirements are provided on the following pages.
• A location that allows for proper exhaust installation.
A gas dryer must be exhausted to the outdoors. See
Venting the dryer.
• A grounded electrical outlet located within 2 ft.
(61 cm) of either side of the dryer. See Connecting
electric dryers.
Do not operate your dryer at temperature below 41°F(5°C) and temperature over 95°F(35°C). At lower temperatures,
the dryer might not shut off at the end of an automatic cycle. This can result in longer drying times. The dryer must
not be installed or stored in an area where it will be exposed to water and/or weather. Check code requirements.
Some codes limit, or do not permit, installation of the dryer in garages, closets, mobile homes or sleeping quarters.
Contact your local building inspector.
notE
• The floor must be level, with a maximum slope of 1 inch (2.5 cm) under entire dryer. Clothes may not tumble
properly, and automatic sensor cycles may not operate correctly if dryer is not level.
• For a garage installation, you will need to place the dryer at least 18 inches (46 cm) above the floor. The standard
pedestal is 15 inches. You will need 18 inches (46 cm) from the garage floor to the bottom of the dryer.

Clearances

14" max.*
(35.6 cm)
18" min.*
(45.7 cm)
1"* 30" 5"**
(2.5 cm) (76.1 cm) (12.7 cm) (2.5 cm)
14" max.*
InstallatIon spacIng for recessed area or closet InstallatIon
(35,6 cm)
The following spacing dimensions are recommended for this dryer. This dryer has been tested for spacing of 1
18" min.*
(45,7 cm)
inches(2.5cm) clearance on the sides and rear. Recommended spacing should be considered for the following
reasons:
• Additional spacing should be considered for ease of
installation and servicing.
1"* 30" 5"**
• Additional clearances might be required for wall, door (2,5 cm) (76,1 cm) (12,7 cm) (2,5 cm)
and floor moldings.
14" max.*
(35,6 cm)
18" min.*
(45,7 cm)
notE
There should be at least a little space around the dryer (or any other appliance) to eliminate the transfer of
vibration from one to the other. Too much vibration, it could cause them to make noise or touch each other
causing paint damage and making even more noise.
1"* 32,1" 5"**
(2,5 cm) (81,4 cm) (12,7 cm) (2,5 cm)
14" max.*
(35.6 cm)
48 in.
2*
18" min.* (310 cm )
2
(45.7 cm)
24 in.
2*
(155 cm )
2
1"* 30" 5"**
(76.1 cm) (12.7 cm)
14" max.*
(35,6 cm)
48 in.
2*
18" min.* (310 cm )
2
(45,7 cm)
24 in.
2*
(155 cm )
2
1"* 30" 5"**
Requisitos
(76,1 cm) (12,7 cm) deventilación de
lapuerta del armario
14" max.*
(35,6 cm)
48 in.
2*
18" min.* (310 cm )
2
(45,7 cm)
24 in.
2*
(155 cm )
2
1"* 32,1" 5"**
(81,4 cm) (12,7 cm)
InstallatIon InstrUCtIons
• A sturdy floor to support the total dryer weight of 200
lbs (90.7 kg). The combined weight of a companion
appliance should also be considered.
• No other fuel-burning appliance can be installed in the
same closet as a dryer.
3"
*
(7.6 cm)
0"
(0 cm)
39"
(99.1 cm)
3"
*
(7.6 cm)
1" 27" 1"
(2.5 cm) (68.6cm) (2.5 cm)
3"
*
(7,6 cm)
0"
(0 cm)
39"
(99,1 cm)
• Additional spacing should be considered on all sides
3"
*
(7,6 cm)
of the dryer to reduce noise transfer.
1" 27" 1"
For closet installation, with a door, minimum (2,5 cm) (68,6cm) (2,5 cm)
ventilation openings in the top and bottom of the
door are required. Louvered doors with equivalent
ventilation openings are acceptable.
3"
*
(7,6 cm)
• Companion appliance spacing should also be
0"
considered.
(0 cm)
(103,6 cm)
3"
*
(7,6 cm)
1" 29" 1"
(2,5 cm) (673,6 cm) (2,5 cm)
1" 27" 1"
(2.5 cm) (68.6 cm) (2.5 cm)
1" 27" 1"
(2,5 cm) (68,6 cm) (2,5 cm)
40.8"
1" 29" 1"
(2,5 cm) (73,6 cm) (2,5 cm)
15